Screen protectors - how to fit it simply and easy / dry and wet fitting
visit our shop for:
- Nokia screen protector
- LG screen protector
- Apple screen protector
- Sony Ericsson screen protector
- Nintendo DS screen protector
- Sony PSP screen protector
- TomTom screen protector
Dry fitting
First step.
To help yourself you should cut your assembly into stripes. We recommend you to make stripes about 1 cm width x 2,5 cm length. These stripes can be used quite often. With the help of the stripes you can be sure that no fingerprints on the adhesive side are left. Of course, you can make it without them! But better take the foil paper with protective display and stick the strips on it. Place the strips with enough ledges, so you will have sufficient space to touch.
Second step.
The main point, stripes help you not to leave fingerprints on the sticky side.
Next step is to clean surface of the monitor thoroughly; it should be tidy and dust-free. To do these use a cleaning cloth. Please, do not use a paper towel.
Fourth step.
Take the foil strip and replace protective display with the help of the stripes on the monitor. If you touch just ledges of the stripes, you will avoid unnecessary fingerprints.
Fifth step.
The protective display is placed on the monitor of the device. You will need something with the squeegee pressure from below. It should move smoothly from the left edge through the centre up to the right edge. Make sure that after squeegee pressure there are no any bubbles of air.
Sixth step.
Remove ledges of assisting stripes. To make it is easy. It should be no marks of the stripes after doing that.
Clean the screen again. Well done!
First step.
To help yourself you should cut your assembly into stripes. We recommend you to make stripes about 1 cm width x 2,5 cm length. These stripes can be used quite often. With the help of the stripes you can be sure that no fingerprints on the adhesive side are left. Of course, you can make it without them! But better take the foil paper with protective display and stick the strips on it. Place the strips with enough ledges, so you will have sufficient space to touch.
Second step.
The main point, stripes help you not to leave fingerprints on the sticky side.
Next step is to clean surface of the monitor thoroughly; it should be tidy and dust-free. To do these use a cleaning cloth. Please, do not use a paper towel.
Fourth step.
You will need a flat plate with a mixture of water and little soapsuds on it. Dip the Screen protector in the plate with soap liquid. After that pull out and shake the excess water well. Thanking the water-soap mixture, you have an ability to place protection screen in the optimal position. Without right position protective foil can move or have air bubbles.
Fifth step.
Make sure the Screen protector is properly aligned and gently press from one corner and disperse pressure throughout. Rub the Screen protector from the center outward and then press the moisture out. The remaining moisture can dry up in a warm place in two or three hours. This method is suitable for all types of foils and laminates. You'll be amazed by the read.
Copyright © UK-GOODS 2008-2009. All Rights Reserved